1. Wallpaper cutting: Before wallpapering, first cut the wallpaper, according to the width and height of the wall, reserve 5 cm above and below the height of the wall for cutting. Be careful to choose to crop the same roll of wallpaper to prevent the wallpaper from getting worse due to quality issues.
2. Wall treatment: The wall that needs to be wallpapered must be flat, dry, clean, and there is no unevenness. Therefore, brush the base film or varnish before applying the wallpaper.
3. Brush wallpaper glue: wallpaper is posted by special glue, wallpaper glue should be evenly brushed on the wall, the thickness is about 2 mm. But you can't cope with the effort to brush the glue directly on the back of the non-woven wallpaper, and you can't even wet it. The glue of the non-woven wallpaper is thicker and thicker than other wallpapers, so that the fluidity of the wallpaper is reduced, and it can be smoothly attached to the wall surface.
4. Wallpaper: Post the non-woven wallpaper according to the order and location of the cut, be careful not to wrinkle the wallpaper.
5. Wallpaper cutting: After the wallpaper is finished, the trimming should be carried out on the lap, and the wallpaper should be cut according to the pattern, about 3 cm. Cut the scissors to ensure sharpness, do not have burrs, pay attention to the angle and strength of the lower knife, and ensure that the cutting is done once, so be careful not to hurt the surface of the wall.
6. Cleaning: If you find that the wallpaper surface is dusty, it is best to use a short brush or tweezers to gently rub, but do not wipe with a damp cloth.
