Dry stickers must master the scale of the glue applied. At the same time, certain techniques must be paid attention to during construction:
First of all, in order to prevent the wallpaper from being moldy, it is necessary to first brush the varnish on the wall before the paving. To prevent the wallpaper from being drummed, the paint must be dried;
Secondly, special glue should be used, and the ratio should be strictly in accordance with the instructions;
Third, when the wallpaper needs to be laid, the flower should start from the middle;
Fourth, if the glue overflows too much on the surface of the wallpaper, it must be scrubbed with a sponge and cannot be scrubbed with a towel;
Fifth, after the wallpaper is attached, open the seams of the wallpaper and brush the glue again with a small brush. At the same time, the seam can not be scrubbed too many times, otherwise the wallpaper will be black;
Sixth, if the wallpaper produces a drum, it is necessary to break the drum to put the glue or take out the air and put it into the glue for processing. Wallpapers are generally divided into wet stickers and dry stickers. The method of wet sticking was once widely adopted, but the wet stick has certain defects. After the bottom paper is immersed in water, the glue is difficult to adhere to the surface of the paper, causing the phenomenon of warping. Nowadays, the method of dry sticking is widely used. The advantage is that after the glue is applied on the back of the wallpaper, it is pasted for a few minutes and then pasted, the strength is more than doubled than that of the wet patch, and the common warping phenomenon is not generated on both sides of the seam.
